Suspension

Ok, In this post I will be explaining how I installed my K&W variant 3 race coil over suspension on the front.

First off sit down, rest the coil over in your lap, then push down on the purple insert as seen in this picture and remove the bolt. It will appear like it will release and shoot springs everywhere, but it will not do this so you don't have to hold on to it.

This is the order of the Setup, the metal washer thing goes on top "above" the strut tower in the chassis. the rubber mount which is "not" OEM(supplied by 034), has one green side on it, that must face the purple washer on the shock. I believe when I took this apart (been a while) that the green was facing upwards instead of the way I just told you, yet this is the way I was told to do it. So don't panic. With this mount green down, and if I'm right then Green up on OEM. This picture was taken with the bolt on, however Follow step one and Remove the bold before putting the rubber mount on, bolt goes on last.

Place the rubber mount on the shock, I used a jack for this, however some ways may work better. hold it still and aligned and jack it up into the tower, put the metal insert and screw the bolt back on.

Then this is the result, The front right coil over installed without any other attachments.......soon to come ;) so stay tuned.